Planet Technology IP DSLAM IDL-4801 - Manual (Page 157)

IP DSLAM 157
5.5.3 ATM OAM Loopback Commands
5.5.3.1 Get oam lpbk vc
Description:
Use this command to get.
Command Syntax:
get oam lpbk vc [ifname ]
5.5.3.2 Modify oam lpbk vc
Description:
Use this command to modify.
Command Syntax:
modify oam lpbk vc ifname [e2e | seg] [lbid ]
Parameters:
Name Description
ifname Interface Index of the ATM port, on which this VC is getting
configured.
Type: Modify － Mandatory
Get － Mandatory
e2e | seg This specifies the loop back type used. It may be: e2e or segment.
Type: Modify － Optional
Lbid < lbid-val> This defines the loopback site, which will loopback the cell.
Type: Modify － Optional
Example:
$ get oam lpbk vc ifname aal5-0
Output:
IfName : aal5-0 VPI : 1 VCI : 1
LB Type : e2e
OAM Location Id : 0xffffffffffffffffffffffffffffffff
OAM LB Result : E2e Succeeded