Planet Technology IP DSLAM IDL-4801 User Manual
Page 292
IDL series User Guide
292
<atucconfpsdmaskds-val>
applicable at the U-C2 reference point. This MIB PSD mask may
impose PSD restrictions in addition to the Limit PSD mask defined in
the relevant Recommendation (e.g., G.992.5). (length = 4 bytes).
Type: Modify -- Optional
aturconfpsdmaskus
<aturconfpsdmaskus-val>
This configuration parameter defines that the upstream PSD mask
applicable at the U C2 reference point. This MIB PSD mask may
impose PSD restrictions in addition to the Limit PSD mask defined in
the relevant Recommendation (e.g., G.992.5). It is available only for
Annexes J and M of ADSL2/ADSL2plus.(length = 4 bytes)
Type: Modify -- Optional
aturratemode fixed |
adaptAtStartup |
adaptAtRuntime
Defines what form of transmit rate adaptation is configured on this
modem. The default value mentioned is an indicative value only.
Type: Modify -- Optional
aturconfmininp Inp0 |
InpPoint5 | Inp1 | Inp2 |
InpAuto | Inp4 | Inp8 | Inp16
Parameter used to specify the minimum impulse noise protection for
the upstream bearer channel. Supported for ADSL2/ADSL2plus ONLY
Type: Modify -- Optional
gsannexcoltocxswitch
CxSwitch19DB |
CxSwitch20DB |
CxSwitch21DB |
CxSwitch22DB |
CxSwitch23DB |
CxSwitch24DB |
CxSwitch25DB |
CxSwitch26DB |
CxSwitch27DB |
CxSwitch28DB |
CxSwitch29DB |
CxSwitch30DB
Conexant parameter that is used to configure the switching point
between DBM-OL and XOL.(length = 4 bytes)
Type: Modify -- Optional
atucconfgsannexcswitch
Gspan19DB | Gspan20DB |
Gspan21DB | Gspan22DB |
Gspan23DB | Gspan24DB |
Gspan25DB | GspanPlus7DB
| GspanPlus8DB |
GspanPlus9DB |
GspanPlus10DB |
GspanPlus11DB |
GspanPlus12DB |
GspanPlus13DB |
GspanPlus14DB |
Conexant parameter that is used to configure the switching point
between Annex C and G.Span (IFM) and between Annex C and
G.Span Plus.(length = 4 bytes)
Type: Modify -- Optional