Planet Technology IP DSLAM IDL-4801 - Manual (Page 212)

IDL series User Guide 212
Cautions:
z
An entry in this table shall not be applicable for a bridge port created over
PPPOE/IPOE interface.
References:
z
bridge static multicast
5.7.2 Bridge mcast forwarding Commands
5.7.2.1 Get bridge mcast forwarding
Description:
Use this command to get.
Command Syntax:
get bridge mcast forwarding [vlanid ] [macaddr ]
Parameters:
Name Description
vlanid <vlanid-val> The VLAN id for this VLAN. In devices supporting "Shared Vlan for
multicast" capability, the information for a multicast MAC address is
shared across VLANS. Hence, vlanid is not required and is passed as
zero. In devices supporting "Independent Vlan for multicast" capability.
Each vlan can have its own information for a multicast MAC address.
Hence, VLAN id is a mandatory parameter and a valid value of vlanid
must be passed. For No Vlan case VLAN id is not required. When Vlan
transparency feature is supported, the valid range for vlanid also
includes 4097. In case of "Shared Vlan Multicast also there shall always
be a seperate entry for 4097 if the VLAN with that VLAN Id is created.
VLAN here means the 802.1q Vlan in case of Native Vlan mode and
Virtual Vlan in case of Stacked Vlan Mode.
Type: Modify － Optional
Get － Optional
Valid values: 0 - 4095
macaddr
<macaddr-val>
The destination Group MAC address in a frame, to which this entry's
filtering information applies
Type: Get -- Optional