Planet Technology IP DSLAM IDL-4801 - Manual (Page 544)

IDL series User Guide 544
actionval The parameter should contain valid value for some actions that
require an additional input.For sendtocontrol and copytocontrol
actions this parameter should contain control flow id (0 - 3).
Other values are invalid for this action. For modifytos action this
parameter should contain value to be set in tos field in the
packet in the range 0 to 255. Other values are invalid for this
action. The application of this value is dependent on the mask
field. For setbaclevel action this parameter should contain Buffer
Admission Control level 0 or 1. Other values are invalid for this
action. This parameter is ignored for other actions.
Type: Create -- Optional
Modify -- Optional
Valid values: 0 - 0xffffffff
Default value: 0
actionmask This field is valid for sendtocontrol, copytocontrol and modifytos
actions only.For sendtocontrol and copytocontrol actions this
parameter should contain trap disabled (0xffffffff) or trap enabled
(0x00000000). Other values are invalid for this action.Only lower
8-bits are taken into consideration for modifytos action and other
bits are ignored. In the mask if a bit location contains 1, then the
corresponding bit in the TOS field is overwritten with the
corresponding bit in action value. In the mask if a bit location
contains 0, then the corresponding bit in the TOS field remains
unchanged.
Type: Create -- Optional
Modify -- Optional
Valid values: 0 - 0xffffffff
Default value: 0xffffffff
description Description of the application that receives packets matching
this RL. This field is mandatory if Action is 'sendtocontrol' or
'copytocontrol'.The description string should not begin with
underscore '_' as it is reserved for special usage e.g.
_PPPOE_CONTROL.
Type: Create -- Optional
Modify -- Optional
Default value: "\0"
Example:
$ create rl actionprofile info profileid 1 result conform action copytocontrol actionval
0x00000000 actionmask 0xffffffff description lacp