Planet Technology IP DSLAM IDL-4801 - Manual (Page 133)

IP DSLAM 133
Parameters:
Name Description
ifname ifname This specifies the aggregator interface index on which active standby is to be
enabled. Valid Value is aggr-0.
Type: Modify -- Mandatory
Get -- Optional
Valid values: aggr-0
Status
enable | disable
This specifies whether active standby mode is to be enabled or not.
Type: Modify -- Optional
Example:
$ get actstdby aggr info IfName aggr-0
Output:
Interface Index : aggr-0
Status : Enable
Output Fields:
Field Description
Interface Index This specifies the aggregator interface index on which
active standby is to be enabled. Valid Value is aggr-0.
Status This specifies whether active standby mode is to be
enabled or not.
Caution:
z Active Standby mode shall not be enabled, if aggregator interface and
redundancy aggregator are not created, or if LACP aggregator is created for the
aggregator interface.
z
If only Active Standby is desired and no load sharing is expected then bridge
port shall be created over the aggregator only after Active Standby has been
enabled for redundancy aggregator. If the bridge port is created over aggregator
before enabling Active Standby for it, the load sharing shall start and continue till
Active Standby is enabled.
z
References:
Redundancy commands.