beautypg.com

3 lacp aggr commands, 1 get lacp aggr, 2 create lacp aggr – Planet Technology IP DSLAM IDL-4801 User Manual

Page 138

background image

IDL series User Guide

138

interface as the management vlan id. In case the management vlan

(virtual vlan mapped to S-VLAN and C-VLAN for the frame) doesn't

exist (ie. Virtual vlan mapped to 'mgmtsvlanid' or the associated '

psvlanid ', if 'mgmtsvlanid' is zero) on the system then IP based

management shall not happen on the interface till the corresponding

virtual-VLAN is created with the Net side port as its member.

Tagged Mgmt PDU Prio Priority to be set in Tagged Ethernet PDUs sent on Management

VLAN over this interface. This field is valid only if either 'ip' field is

non-zero or 'usedhcp' field is true. In Native Vlan mode this priority

shall be used for C-Vlan tag while in stacked vlan mode it shall be

used for S-Vlan tag.

Oper Status

The actual/current state of the interface. It can be either up or down.

Admin Status

The desired state of the interface. It may be either Up or Down.

Cautions:
z

If an aggregator interface is being created, all configurations of aggregated

links (layer2 Ethernet interfaces), should be same.

5.4.3 LACP Aggr Commands

5.4.3.1 Get lacp aggr

Description:

Use this command to get.

Command Syntax:

gets lacp aggr [aggrifname ]

5.4.3.2 Create lacp aggr

Description:

Use this command to create.

Command Syntax:

create lacp aggr aggrifname [actorsystemprio

] [actoradminkey ]

[collectormaxdelay ] [aggrtype Static | Lacp]

This manual is related to the following products: