Planet Technology IP DSLAM IDL-4801 - Manual (Page 616)

IDL series User Guide 616
EthType
This specifies the Defines the ethernet types – data
, mgmt, or both. It is a bitmask.
Num of LBRams This specifies the number of LBRams in the system.
Num of Chips This specifies the number of Chips in the system.
Num of Ports This specifies the number of Ports per Chip in the system.
Interface Type
This specifies the InterfaceType. Following are the values it
can take – Host Bus, PCI, Utopia
Chip Type This specifies the Type of Chip – G24, G16, and octane.
Serial Number
This specifies the vendor specific string that identifies the
vendor equipment.
Vendor Id This specifies the binary vendor identification field.
Version Number
This specifies the vendor specific version number
sent by this ATU as part of the initialization message
Base Addr This specifies the base address of the chip.
LBRam This specifies the LBRam associated with the chip
Logical To Physical
Port Mapping
This specifies the Logical To Physical Port Mapping.
No of UARTs This specifies the number of UARTs configured.
HSSL Port Id This specifies the HSSL port to be used for UART.
Baud Rate This specifies the Baud Rate of the port
Data Bits This specifies the number of data bits to be used
Stop Bit This specifies the stop bits used on HSSL – 1, 2, 1.5
Parity This specifies the parity used on HSSL – even, odd, none
UART Mode This specifies the UART Mode – polling, interrupt based
Application Type This specifies the application name using this UART.
5.25.7 System reboot info Commands
5.25.7.1 Get system reboot info
Description:
This command is used for displaying a list of reboot failures that were encountered
when the system was trying to come up.
Command Syntax:
get system reboot info [numentries]