Planet Technology IP DSLAM IDL-4801 - Manual (Page 201)

IP DSLAM 201
this node, in units of seconds.
Br Max Age(Sec) The maximum age of Spanning Tree Protocol information learned
from the network on any port before it is discarded, in units of
seconds, when this bridge is the root of the spanning tree. Note
that IEEE-802.1D specifies that the range for this parameter is
related to the value of dot1dStpBridgeHelloTime.
Curr Max Age (Sec) The maximum age of Spanning Tree Protocol information learned
from the network on any port before it is discarded, in units of
seconds. This is the actual value that this bridge is currently
using.
Br Hello Time(Sec) The value that all bridges use for HelloTime when this bridge is
acting as the root.
Curr Hello Time(Sec) The amount of time between the transmission of Configuration
bridge PDUs by this node on any port when it is the root of the
spanning tree or trying to become so, in units of second. This is
the actual value that this bridge is currently using.
Br Fwd Delay(Sec) The value that all bridges use for ForwardDelay when this bridge
is acting as the root. Note that IEEE-802.1D specifies that the
range for this parameter is related to the value of
dot1dStpBridgeMaxAge.
Curr Fwd Delay (Sec) This is the actual time value, measured in units of seconds,
controls how fast a port changes its spanning state when moving
towards the Forwarding state. The value determines how long the
port stays in each of the Listening and Learning states, which
precede the Forwarding state. This value is also used, when a
topology change has been detected and is underway, to age all
dynamic entries in the Forwarding Database.
STP status Spanning Tree Protocol to be enabled on the Bridge or not.
Spanning Tree Protocol can not be enabled in Stacked Vlan
mode.
References:
z
get stp info command
z stp port related commands.