beautypg.com

Planet Technology IP DSLAM IDL-4801 User Manual

Page 286

background image

IDL series User Guide

286

Type: Modify -- Optional

atucgsbitswap Disable |

Enable

This parameter enables/disables bit swapping

Type: Modify -- Optional

atucgsntr LocalOcs |

Refck8K

This parameter enables/disables NTR on a per chip basis

Type: Modify -- Optional

atucgsalctlusver Unknown

For T1.413 demo purposes only

Type: Modify -- Optional

atucgsusecustombin Enable

| Disable

This parameter enables/disables user selection which of the 511 bins

will be enabled for upstream and downstream transmission.

Type: Modify -- Optional

atucgsdnbinusage

<atucgsdnbinusage-val>

'1' in bit position indicates usage of corresponding bin,whereas a '0'

disables usage of corresponding bin.

Type: Modify -- Optional

atucgsmaxdco 64 | 128 | 256

| 511

Maximum interleaving depth supported by the customer's hardware

Type: Modify -- Optional

atucgsfullretrain Enable |

Disable

Indicates enable/disable of auto retrain capability

Type: Modify -- Optional

atucgspsdmasktype

CoMsk2 | FlatMsk | CabMsk2

| CoMsk2Rfi | FlatMskRfi |

CabMsk2Rfi | CoMsk2Rfi0 |

Adsl2NonovlpM1 |

Adsl2NonovlpM2 |

Adsl2NonovlpFlat

This parameter selects the PSD mask option to be used

Type: Modify -- Optional

atucgseraseprofs enable |

disable

This parameter enables/disables the ability to erase all fast retrain

profiles at startup

Type: Modify -- Optional

atucgsextrsmemory

notpresent | present

Indicates whether customer's Hardware uses external RS RAM

Type: Modify -- Optional

paramhybridlossteststart

<paramhybridlossteststart-val

>

Start bin for range of bins to be measured. The default value mentioned

is an indicative value only, for exact value refer to document number

DO-400523-AN and DO-401163-AN.

Type: Modify -- Optional

Valid values: 0x0 - 0x1ff

paramhybridlosstestend

<paramhybridlosstestend-val

>

End bin for range of bins to be measured.

Type: Modify -- Optional

Valid values: 0x0 - 0x1ff

dmttrellis on | off

This parameter enables/disables trellis coding. Trellis coding should

always be enabled for its clear performance advantage.

Type: Modify -- Optional

This manual is related to the following products: