Planet Technology IP DSLAM IDL-4801 - Manual (Page 325)

IP DSLAM 325
together. In case Iftype is ‘slave’, then this field can not be
set to GS_TRUE.
Ip Address This parameter specifies the IP address configured for the
interface. This is required to be configured only if this
interface is used for management IP traffic. If it is not
configured and 'etherUseDhcp' is configured as
GS_FALSE, then management IP traffic will not flow
through this interface. ‘Modify’ of IP Address for an Ethernet
interface shall be supported only if some IP address is
configured on the interface or 'etherUseDhcp' was
configured to "GS_TRUE" previously. If Usedhcp is
GS_TRUE and ‘modify’ is done for this field, then Usedhcp
field shall be set to GS_FALSE. Both ‘Usedhcp’ and this
field shall not be specified together.
Mask This parameter specifies the network mask configured for
the interface. This is given in conjunction with IP Address
configured and shall be given only if IP address has been
given. This shall be removed whenever IP Address is
removed. ’Modify’ of network mask for an Ethernet interface
shall be supported only if some IP address is configured on
the interface or 'etherUseDhcp' was configured to
"GS_TRUE" previously. If Usedhcp is GS_TRUE
and ’modify’ is done for this field, then usedhcp field shall
be set to GS_FALSE. Both usedhcp and this field shall not
be specified together.
pkttype This parameter defines the packet type supported by the
interface. ‘etherPktTypeSupported’ shall be configured for
every Ethernet interface. By default, all packets will be
transmitted. The interface shall not transmit any other
packet type than that configured.
Orl This parameter specifies the output rate limiting value to be
applied on this Interface.The units for the same is in
Mbits/sec
Configured Duplex The duplex mode to be used by the interface, as configured
by the user.
Duplex This parameter defines the modes, in which the Ethernet
Interface can come up. It can be configured as ‘auto’, ‘half’,
‘full duplex’ or a combination of these. Based on the values
configured, the Ethernet interface negotiates with the peer
entity.