Planet Technology IP DSLAM IDL-4801 - Manual (Page 703)

IP DSLAM 703
802.1X CLI commands
Specifying RADIUS Servers
To specify one or more RADIUS servers, perform this task in privileged mode:
Task Command
Step 1 Specify the IP address of up to three RADIUS
servers. Specify the primary server using the
primary keyword. Optionally, specify the destination
UDP port to use on the server.
create radius server
ip_addr [acct-port
port_number] [primary]
Step 2 Verify the RADIUS server configuration. get radius
Specifying the RADIUS Key
Use the RADIUS key to encrypt and authenticate all communication between the
RADIUS client and server. You must configure the same key on the client and the
RADIUS server.
The length of the key is limited to 65 characters. It can include any printable ASCII
characters except tabs.
To specify the RADIUS key, perform this task in privileged mode:
Task Command
Step 1 Specify the RADIUS key that is used to encrypt
packets that are sent to the RADIUS server.
create radius key key
Step 2 Verify the RADIUS configuration. get radius
Configuring 802.1X Authentication
The following sections describe how to configure 802.1X authentication on the switch.