Planet Technology IP DSLAM IDL-4801 - Manual (Page 297)

IP DSLAM 297
bps. Also refer to 'adslAtucConfRateChanRatio' for information
regarding RADSL mode and refer to ATU-R transmit rate for
ATU-C receive rates.
Fast Max Tx Rate(bps) Configured Maximum Transmit rate for 'Fast' channels, in bps.
Also refer to 'adslAtucConfRateChanRatio' for information
regarding RADSL mode and ATU-R transmit rate for ATU-C
receive rates.
Intl Max Tx Rate(bps) Configured Maximum Transmit rate for 'Interleave' channels, in
bps. Also refer to 'adslAtucConfRateChanRatio' for information
regarding RADSL mode and ATU-R transmit rate for ATU-C
receive rates.
Max Intl Delay(ms) Configured maximum Interleave Delay for this channel.
Interleave delay applies only to the interleave channel and defines
the mapping (relative spacing) between subsequent input bytes at
the interleaver input and their placement in the bit stream at the
interleaver output. Larger numbers provide greater separation
between consecutive input bytes in the output bit stream, allowing
for improved impulse noise immunity at the expense of payload
latency.
GsTxStartBin The lowest bin number allowed for Tx signal.
GsTxEndBin The highest bin number allowed for Tx signal.
GsRxStartBin The lowest bin number allowed for Rx signal.
GsRxEndBin The highest bin number allowed for Rx signal.
GsMaxBitsPerBin The maximum Rx number of bits per bin.
GsMaxDCo Maximum interleaving depth supported by the customer's
hardware
GsRxBinAdjust This parameter employs Rx Start/End bin settings
GsAdi2x For non-standard compliant ADI CPE
GsInitiate Specifies which end initiates startup. It is also used to send a
C-tone to the remote unit.
GsTxPowerAtten The value in dB of Tx power attenuation
GsCodingGain Sets the coding gain in dB increments
GsRsFastOvrhdDown This parameter sets the percentage overhead for the downstream
fast buffer. RS can also be disabled.
GsRsIntCorrectionDown This parameter sets the correction time for the downstream
interleaved buffer.RS can also be disabled.
GsRsFastOvrhdUp This parameter sets the percentage overhead for the upstream
fast buffer.RS can also be disabled.
GsDrStby This parameter provides the ability to disable power to the line
driver