Planet Technology IP DSLAM IDL-4801 - Manual (Page 511)

IP DSLAM 511
Output Fields:
FIELD Description
Ifname The PPPR interface.
Low IfName This specifies the name of the lower AAL5
interface.
Max PDU Size This specifies the maximum PDU size on a PPPR
interface.
Ter Ack TimeOut Time in seconds to wait for LCP terminate Ack,
after sending a terminate request.
Lowif Toggle TimeOut Time in seconds to wait for lowif to come up
without tearing down the pppr session.
Nature Specifies if the interface is dynamic or static in
nature.
Config Status This mode describes the configuration status for
the interface. If the "config" bit is set, this interface
shall be created, but will have a dormant status.
Only after the receipt of an pppoa packet from the
CPE side, this interface shall become active. The
"In-Use" and "Not-In-Use" bits are read-only bits.
The "Not-In-Use" bit indicates that the entry is
dormant and "In-Use" bit indicates that the entry is
activated.
Operational Status The actual/current state of the interface. It may be
either Up or Down.
Admin Status The desired state of the interface. It may be either
Up or Down.
PPPOA PacketsPrio Priority to be set in tagged PPPOE frames or PPP
packets sent over this port from Control
Plane .This priority shall also be used for choice of
traffic class/ Queue on outgoing interface whether
the frame is tagged or not.In case the bridge port is
over an Aggregated ATM VC, this will also be
used to identify the VC, on which the packet is to
be sent.