Planet Technology IP DSLAM IDL-4801 - Manual (Page 324)

IDL series User Guide 324
Output:
Verbose Mode On
Entry Created
Interface : eth-0
Type : Uplink UseDhcp : False
IP Address : 192.168.1.1 Mask : 255.255.0.0
Pkt Type : Mcast
Orl(mbps) : 100
Configured Duplex : Auto Duplex : None
Configured Speed : Auto
Profile Name : SPPROFILE
Mgmt VLAN Index : 2
Mgmt S-VLAN Index : 2
Mgmt T-VLAN Index : 2
Tagged Mgmt PDU Prio: 2
trfclassprofileid : 1
Ctl Pkts Instance Id:1 Ctl Pkts Group Id : 1
Speed : -
Operational Status : Down Admin Status : Up
Verbose Mode Off:
Entry Created
Output field:
Field Description
If-Name This parameter specifies the interface index used for the
Ethernet type of interfaces. Valid Values starts from eth-0
and continues to eth-*
Type This parameter specifies the type of the Ethernet interfaces.
The Net is towards the NET side (2 at most) and slave
means the physical interface connected to the slave device.
UseDhcp This parameter specifies whether a DHCP client is to be
triggered to obtain an IP address for this interface. If this is
configured as GS_FALSE and ‘etherIfIpAddress’ is not
configured, then management IP traffic will not flow through
the interface. If an IP address is configured and ’modify’ is
done for this field, then ‘tEtherIfIpAddress’ and
‘tAggrIfNetMask’ fields shall be set to Zero (0.0.0.0). Both
Usedhcp and ‘tEtherIfIpAddress’ shall not be specified