Planet Technology IP DSLAM IDL-4801 - Manual (Page 653)

IP DSLAM 653
permitted only if there is a Static VLAN Registration Entry for the
VLAN concerned, in which, the Registrar Administrative Control value
for this port is, Normal Registration.
GVRP PacketsPrio' For the GVRP PDUs generated by the Control Plane, this priority shall
be used for choice of traffic class/ Queue on outgoing interface. In
case the bridge port is over an Aggregated ATM VC, this will also be
used to identify the VC, on which the packet is to be sent.
PS VLAN Index Port service Vlan Index, the Service VLAN ID assigned to frames
received on this port. This is applicable only to Non-Provider ports.
The value zero here means that this field is not applicable. psvlanid
and ctosprofileid both can be non-zero. But they both can not be zero.
In case of bridge port on PPPoE and IPoE interfaces psvlanid value
must be non-zero, ctosprofileid is ignored for such a port. For other
bridge ports† psvlanid value can be zero. If both psvlanid and
ctosprofileid have non-zero value for such ports, the ctosprofileid shall
be applied and psvlanid shall be ignored
Port Provider Status This specifies if the port is a provider port or a Non-Provider port as
per Vlan stacking model. This field is applicable only in Vlan stacking
scenario. The modification of this parameter is allowed only when the
bridge port is disabled. If the value of this field is
GS_STATE_ENABLE i.e the port is a provider port, then Priority of the
incoming C-Vlan tag is kept preserved irrespective of
gsvSVlanCvlanQosPreserveMode of the Svlan to which the packet
belongs to.
CtoS Profile Id This specifies the CtoS profileId for the Vlan Map profile associated†
with this interface. Value zero for this means no CtoS profile
associated with this port.† psvlanid and ctosprofileid both can be
non-zero. But they both can not be zero. In case of bridge port on
PPPoE and IPoE interfaces psvlanid value must be non-zero,
ctosprofileid is ignored for such a port. For other bridge ports†
psvlanid value can be zero. If both psvlanid and ctosprofileid have
non-zero value for such ports, the ctosprofileid shall be applied and
psvlanid shall be ignored.
References:
gvrp commands