Planet Technology IP DSLAM IDL-4801 - Manual (Page 185)

IP DSLAM 185
of this parameter shall depend on the port type. For Net side ports, the
default value shall be disable and for the cpe side ports the default value
shall be enable. This field is unused if the bridge port is created over an
PPPOE/IPOE interface or PPPOE/ IPOE is sensed. Any value of this field
shall be ignored for a bridge port created over a PPPOE/IPOE interface.
Type: Modify － Optional
proxyarpstatus enable
|disable
The Proxy Arp Status on this bridge port. The value enable of this field
indicates that Proxy Arp request can be received through this port. This
field can be enabled only on bridge port created over ethernet or
aggregator interface. Before enabling this field user should create a filter
rule with rule action as Copy to Control and rule description as
IPOE_CONTROL and map it to all those interfaces through which user
wants to receive proxy arp requests.
Type: Modify － Optional
arptstatus Enable |
Disable
This specifies whether ARP translation will be done on the ARP packets
received/transmitted on this port. When enabled, ARP source MAC
address of the incoming ARP packets (both request/reply) will be changed
to virtual MAC address (if applicable) and the ARP target MAC address of
the outgoing ARP reply packets will be changed to the original host MAC
address (if applicable).
Type: Modify -- Optional
darpstatus Enable |
Disable
This specifies whether the ARP packets received on this bridge port are to
be directed to a single port using (VLANId, IP address) to bridge port
mapping learnt using DRA. This field can be enabled only on the NET
side bridge port. This attribute is effective in conjunction with the attribute
'gsv dot1qVlanStaticDirectedARP' of 'Dot1qVlanStatic' MO. ARP
packets are to be directed as mentioned above, only if both the flags are
enabled. If any of the two is disabled, the ARP packets will be forwarded
as per the normal bridging flow.
Type: Modify -- Optional
porttype trusted |
untrusted
This field specifies whether the port is trusted or not. This information is
used by some of the control plane applications to send packet on trusted
ports, in case the application fails to uniquely determine a port.
Type: Modify -- Optional
Example:
$ create bridge port intf ifname eth-0 portid 10 maxucast 10 learning enable
stickystatus enable status enable fdbmodify disable aclglbdenyapply Disable
aclglbtrackapply Disable proxyarpstatus enable arptstatus enable darpstatus
enable porttype trusted