IPitomy IP1100+ PBX Administrator Guide - Manual (Page 62)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 44 v4.0.1
www.ipitomy.com
Can Reinvite
This parameter allows a mechanism to reconnecting calls midstream.
• YES = if the phone type allows the re-invite feature
• NO = if the phone type does not allow the re-invite feature
• N/A = accepts the system wide default defined under PBX
Setup
SIP Advanced. If the default setting is acceptable and works
within your business, we recommend leaving the parameter set to N/A.
Send Remote Party
ID Usually not required. Leave on “N/A” unless advised differently by tech
support.
Trust Remote Party
ID Usually not required. Leave on “N/A” unless advised differently by tech
support.
Insecure
This parameter allows you to specify how to handle connections with peers.
Explanation of the different options available on the drop-down list are:
• PORT = Ignore the port number where authentication came from.
• INVITE = Do not require the initial invite to authenticate.
• PORT+INVITE = Do not require initial invite to authenticate and ignore
the port where the request came from.
• YES – To match a peer based by IP Address only and not the port.
• VERY – To allow registered hosts to call without re-authenticating.
Allow Codecs
Encodes a stream or signal for transmission. Select which codecs will be
enabled for this provider. Can typically be left to defaults.
Phone Numbers Section
Phone Numbers
This is where you would configure any DID information. Only numbers or a +
should be entered for a DID. Once configured, you can define a different
inbound destination for each number, allowing you to route calls to separate
places. Contact your provider to find out if they are sending 4, 7, or 10 digits
inbound for the DID.
Table 14 – SIP Provider Configuration Settings and Descriptions
Add New SIP Provider
The following section outlines the steps to add a new SIP Provider in the PBX system.
STEPS:
1 Click Providers SIP Providers. The SIP Providers page appears.
2 Click on the button. The Edit SIP Provider page is displayed.
3 Configure the pertinent fields per your SIP Providers instructions. See the table above
for descriptions.
4 Click on the button.
5 Click the Apply Changes link located on the right hand corner of the page, to commit the
changes to the database.