IPitomy IP1100+ PBX Administrator Guide - Manual (Page 47)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 29 v4.0.1
www.ipitomy.com
Feature Description
Service Displays the name of configured services. Typical services on the PBX are:
SIP - Used for Calls
Call Manager - Used for Desktop Call Manager
TFTP – Used by phones to pull down config and firmware files
Ports Displays the ports that were defined for a particular service.
SIP – 5060
Call Manager – 5048
TFTP - 69
Rules Displays the rules that were configured for a particular service.
Deny List – Accepts all traffic, unless specifically defined
Allow List – Denies all traffic, unless specifically defined
Table 9 – Access Control List Definitions
Load Recommended Default
This is the recommended method to set the Access Control List to the typically used settings.
STEPS:
1 Navigate to PBX Setup SIP
2 Set the LocalNet to match the network the PBX is installed on, Save, and Apply Changes
3 Navigate to the Access Control List page, click Load Recommended Default button.
This will create default rules allowing the PBX to communicate to devices on the LocalNet
in regards to SIP, Call Manager, and TFTP
4 Click the Apply Changes link located on the right hand corner of the page, to commit the
changes to the database.
Add New Service
Figure 20 – Access Control List Page - Add New Service Section