IPitomy IP1100+ PBX Administrator Guide - Manual (Page 151)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 133 v4.0.1
www.ipitomy.com
12 Click the button to save the changes.
13 Click the Apply Changes link located at the top right hand corner of the page, to commit
the changes to the database
Configuring Office 2
STEPS:
1 Click on Destinations Branch Offices. The Branch Offices page is displayed.
2 Click on the ADD Office button. The Edit Branch Office page appears.
3 Enter a name in the NAME field that matches that given to the Office 1 PBX. The name
should only contain alpha-numeric characters and no spaces. It should be ONE WORD
ONLY.
4 Enter an external IP address or domain corresponding to the IP of the main office PBX
in the HOST field.
5 Enter a UNIQUE dialing prefix for the extensions connected to the Office 2 PBX.
6 The PASSWORD for Branch Office 2 needs to be the same as the one assigned in the
Branch Office 1 PBX.
7 Select NO for REGISTER.
8 Configure Enable Trunking as needed.
9 Configure Enable Multisite Manager Connection as needed.
10 Set QUALIFY at 0.
11 Configure Enable IAX2 Trunking as needed.
12 Click the button to save the changes.
13 Click the Apply Changes link located at the top right hand corner of the page, to commit
the changes to the database
To setup additional Branch Offices in the PBX, use the steps outlined above.
Keep in mind to use the same logic (pattern) and make sure that the dialing
prefix is unique to each office.