IPitomy IP1100+ PBX Administrator Guide - Manual (Page 234)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 216 v4.0.1
www.ipitomy.com
APPENDICES
Appendix 1: Key Types and Codes
This table describes the function of each key type, and how to manually configure them. It is not advised to
manually configure unless the phone is in a situation where you cannot easily use the PBX to set the keys
(ie: remote phones). Unless specified, the Line field when manually configuring should be set to All.
Key Type Description
BLF
Can be set to an extension or park orbit. Pressing the key will call the extension or
retrieve a call from the park orbit. When an extension is ringing the light will flash,
and when an extension is connected to a call, the light will be solid. Park BLF keys
will lamp when a call is parked in that particular orbit. To manually configure, log
into the phone and set the key to:
Type: BLF
Label: Meaningful Descriptor
Value: The extension or park orbit number to monitor
Line: 1
Speed Dial
Dials the digits entered as for the Value and sends them to the PBX. To manually
configure, log into the phone and set the key to:
Type: Speed dial
Label: Meaningful Descriptor
Value: Any number or feature code that the PBX can recognize
Park
Takes the connected call and parks it in an available orbit from 701-720, starting at
the lowest available slot. When parking, the PBX will tell you audibly which orbit the
call was sent to. To manually configure, log into the phone and set the key to:
Type: Park
Label: Park
Value: ##700#
DND
Places the phone itself in a state where it will not receive calls. This does not
communicate your state to the PBX (see Pause key). To configure manually, log
into the phone and set the key to:
Type: Do Not Disturb
Blind Transfer
This key starts the transfer process and allows you to enter a transfer destination.
Once entered, press Dial or wait for the digit timeout and the call will transfer. This
key is most useful if a phone has no open lines to perform a transfer using the fixed
key on the phone, as it does not open a new line to transfer. To configure manually,
log into the phone and set the key to:
Type: Prefix
Label: Blind Transfer
Value: ##