IPitomy IP1100+ PBX Administrator Guide - Manual (Page 131)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 113 v4.0.1
www.ipitomy.com
Advanced Menu Settings
Figure 60 – Advanced Menu Settings Page
Sections/Fields Description
Response Timeout
This is the number of seconds (0-60) the PBX will wait for digits to be
dialed. If nothing is dialed in the allotted time, the menu will route the
call to the Failover Destination. The minimum and default value is 4.
Digit Timeout
While entering digits, the PBX will wait this many seconds (1-20) after
the last digit was entered to take any actions. Single decimal digits are
permitted. The default value is 2.
Play the Greeting
This is the number of times the greeting will be played before the call is
sent to the fail over destination. Default and minimum value is 1.
Local extension dialing
This indicates whether you are able to dial local extensions from the
menu. Default value is YES.
Note: It is not necessary to designate leading digits for extensions. This
setting alone indicates when digits collected should be compared to the
available list of extensions.
Prompt Padding
This is the time in seconds that the PBX will wait when entering the
menu before playing the prompt. The default is set to 2 seconds.
Enable Admin PIN
This enables the use of DTMF Menu Prompt Administration. When
enabled the user may access the menu from a DTMF-enabled device
and input the PIN to enter into Menu Prompt Administration Default
value is No.
Admin PIN
This is the PIN used to access DTMF Menu Prompt Administration.
Default value is: .
Table 43 – Advanced Settings and Description