Grass Valley Xmedia Server Vertigo Suite v.5.0 - Manual (Page 121)

8-18 XMS Configuration Guide
License management
Verifying an application’s server settings
When an Vertigo Suite application does not find a valid license on start up, it produces a
licensing error (figure
8-9 ). The source of the error may be as simple as incorrect server
settings. These settings allow the Xmedia Server to communicate licensing information to
the application.Therefore, we recommend that you verify the server settings associated with
the application using the application’s S
ETTINGS dialog box.
Figure 8-9. License error dialog box
N
OTE
Additional information about application specific licensing is provided in each of the Vertigo
Suite application’s user manuals (i.e. Xstudio User Manual, Xbuilder User Manual...etc)
To verify that the application’s server settings are properly set:
1.
Select the C HANGE S ERVER S ETTINGS button on the X MEDIA S ERVER L ICENSE E RROR
window (figure 8-9 ).
The application’s S ETTINGS dialog box appears (figure 8-10 ).
Figure 8-10. The application’s Setting dialog box
2. Verify that all of the settings are correct, especially the Xmedia Server’s IP address and
port. If necessary, make the appropriate changes to the settings.
3. Click OK to close the S ETTINGS dialog box.
If it was the server settings that were causing the license error, then the application will
launch correctly now. However, if the X
MEDIA S ERVER L ICENSE E RROR window
immediately appears again, proceed to page 8-21 and follow the instructions for
acquiring and adding a valid application license to the Xmedia Server.