Grass Valley K2 Dyno v.1.6 User Manual
Page 90
90
K2 Dyno Controller User Manual
15 April 2010
Chapter 5 Marking Function
• If you perform a reverse playback with the JOG knob and play the video with the
T-Bar:
In this case, the controller automatically enters the trim mode. The In point is set
as the point where you began to operate the T-Bar while the Out point is set as the
point where you stop the playback moving the T-Bar back to the 0% position.
However, the Out point is not fixed and it will be updated when you operate the
T-Bar again. To fix the Out point, press the
Out
button.
NOTE: If you press the
Live
button after operating the JOG knob or T-Bar, the Out
point is set at the point where the button was pressed and the controller returns to
the live playback.
NOTE: A scene is not created even when you operate the JOG knob, T-Bar, or
Previous/Next button during a live playback if
Auto Scene
is set to OFF in "CLIP"
of the CONFIG screen or if the system is in the pseudo live mode. For more
information, see
"About the pseudo live mode" on page 65
• If you press the
In
/
Out
button during a live playback:
In this case, the controller automatically enters the trim mode. A scene that has a
temporary Out point will be created, setting the point where the
In
button was
pressed as the In point. After that, if you press the
Out
button, the point where you
pressed the button will be fixed as the Out point.
NOTE: Pressing the
Cue Up
button after pressing the
In
or
Out
button during a live
playback cues up to the point where the
In
point was pressed.
• If you press the
In
/
Out
button while playing the record train:
In this case, the controller automatically enters the trim mode. A scene that has a
temporary Out point will be created, setting the playback timecode where the
In
button was pressed as the In point. After that, if you press the
Out
button at the
desired scene after you operate the JOG knob or replay the scene, the playback
timecode where you pressed the button will be fixed as the Out point.
Timecode when the T-Bar
operation was started
Timecode when the
Out
button was pressed