Grass Valley K2 Dyno v.1.6 - Manual (Page 105)

15 April 2010 K2 Dyno Controller User Manual 105
Trimming in a highlight
1. Touch an item in the HIGHLIGHT screen, and then press the Cue Up button.
• When the HIGHLIGHT screen is displayed, you can press the Previous/Next
button to select and cue up at the same time.
• The controller cues up to the In point of the selected item.
2. Press the Shift button, and then press the Match button.
• The playback pointer is moved to the same timecode position on the record train
for the current angle.
NOTE: If you press the Cue Up button after step 2, the playback pointer moves back
to the In point location of the selected highlight item.
NOTE: Match frame operations are available while in the trim mode, as well. For
trimming operations with the playback pointer on a highlight item, you can switch
to trimming on the record train by pressing the
Match button after pressing the
Shift button. Also, you can move the playback pointer to the highlight item by
pressing the Cue Up button while trimming on the record train.
Trimming in a highlight
You can use the following methods for trimming in a highlight: to trim an item move
the playback pointer to a highlight item stored as a clip, or to trim In/Out points move
the playback pointer to the record train side. This section describes a case for
trimming In/Out points on the record train side.
1. Touch and select the item you want to trim in the HIGHLIGHT screen.
In the HIGHLIGHT screen, press the Previous/Next button to select the item you
want to trim.
2. Press the Shift button, and then press the Trim button.
• The controller cues up to the In point location on the record train side of the
selected item.
• The controller enters the trim mode. In the trim mode, the In , Out , and Trim
buttons light up in yellow.
• If a HL item is not completed, the HL Info screen appears with progress
information and controls for deleting or retrying the HL item. This can occur
when generating highlights from multiple marks or scenes, which takes longer
than generating a highlight from single mark or scene.
• The trim mode screen appears. For more information about the indication
meanings and individual panel functions, see the following table. To perform
functions (indicated by the shaded area in the table) that are displayed at the top
of the menu panels shown at the bottom of the screen, press the Shift button, and
then touch the desired menu panel. For more information on how to use the Shift
button, see
"About Shift button operations" on page 21
• If the HL item is not completed, a screen appears with progress information and
controls for deleting or retrying the HL item.
Button operation