Grass Valley K2 Dyno v.1.6 - Manual (Page 180)

180 K2 Dyno Controller User Manual 15 April 2010
Chapter 10 Settings
Specifying the SERVER FILE SYSTEM
• Enter the drive name to specify the USB storage device connected to the Summit.
For example, when you specify a "temp" folder in the USB memory (Drive: D)
connected with the Summit, enter "D:\temp" with the keyboard.
• Enter the computer name to specify the hard disk of the network-connected PC,
not the drive letter.
For example, when you specify a "temp" folder in the hard disk of the PC
network-connected with the Summit, enter "\\Dyno-PC\temp" with the
keyboard. (In this case, the computer name is "Dyno-PC", "temp" folder of the
PC is connected with the Summit, and the drive letter is "Z")
NOTE: Do not use the drive letter to specify the network-connected destination.
NOTE: The specified folder of the destination PC is not required to be connected
during its setting. (It is required to be connected when transferring the data.)
NOTE: Do not specify the local disk (Drive: C, etc.) of the Summit as the
destination because of its protection function.
NOTE: The authentication information (user name and password) is required to
connect to the drive on the network. Configure the PC to allow connection with the
following authentication information in advance.
- User name: Administrator, Password: adminK2, or
- User name: guest, no password
Deleting a session
You can select and delete a session on the local or network Summit.
1. Touch < or > in the CONFIG screen, and then touch SESSION .