Grass Valley K2 Dyno v.1.6 - Manual (Page 80)

80 K2 Dyno Controller User Manual 15 April 2010
Chapter 4 Playback
• You can also perform a slo-mo playback with the T-Bar.
• To exit the Gang mode, press the P1 or P2 button.
NOTE: While in the Gang mode, you can press the Cue Up button to perform a
cueing up operation for all the channels of the Gang mode. In this case, the angle
data to be cued up is the angle that is set as primary in "PLAY1" on the CONFIG
screen.
Transferring the channel control
You can transfer the channel control from K2 Dyno Controller to other application
program, or obtain the abandoned channel control. For example, you can transfer the
channel control to the other program after you cued up to any scene using the K2
Dyno Controller. The other application program can obtain the channel control and
continue the edit operation (playback, etc.).
This section describes the operation of transferring the P1 channel control with the K2
Dyno Director product. This is a Grass Valley application. Contact your Grass Valley
representative for availability.
NOTE: This function cannot be used during the preview control of the on-air
preview mode.
Offering the channel control (Offer mode)
1. Cue up to any scene using the K2 Dyno Controller.
• Locate and put the scene in standby, performing operations such as rewinding
the live video with the JOG knob, or cueing up to the beginning of a playlist or
highlight. For more information about the detailed operation procedures, see the
chapter for each function.
2. Press the Fn button, and then press the P1 button.
• The controller enters the Offer mode and no playback operation for the P1
channel is allowed in the K2 Dyno Controller. The P1 button flashes in yellow,
and it changes to flash in red after the operation to obtain the control is
performed by Dyno Director.
• You can obtain the channel control again with the K2 Dyno Controller while the
P1 button flashes in yellow.
NOTE: When this function is used in the multi-channel mode, you can offer the
channel control assigned to the
P2 button. Press the P2 button and then cue up to
any scene in step 1, and press the Fn button and then press the P2 button in step 2.