Grass Valley K2 Dyno v.1.6 - Manual (Page 106)

106 K2 Dyno Controller User Manual 15 April 2010
Chapter 6 Highlight
.
No. Name Function
(1) Play Shows the timecode of the playback pointer.
(2) Path Shows information about the target to be trimmed.
(3) Name Shows the name of the item to be trimmed.
(4) In Shows the timecode of the In point. Touch the panel to edit the
timecode of the In point.
(5) Out Shows the timecode of the Out point. Touch the panel to edit the
timecode of the Out point.
(6) Dur Shows the duration of the item. Touch the panel to edit the duration.
(7) Angle Changes the camera angle for the item to be trimmed.
(8) Separate Trim Allows you to trim each camera angle data separately when trimming
a highlight item that has recording data from multiple camera angles.
If you perform trimming after turning it on, the result of your editing
will be reflected only to the trimmed camera angle.
(9) Delete Angle Touch Selected to remove the recording data for the selected camera
angle from the protection target. Touch UnSelected to remove the
recording data for the camera angles, other than the selected one, from
the protection target.
(10) GET THUMB It is shown only when the playback pointer is on a highlight item, and
the item is currently cued up. From between the In and Out points of the
highlight item, an image at the playback pointer's position when you
touch this panel is acquired as a thumbnail.
(11) MAX DUR Sets the item duration to "12 hours-2 frames".
BACK Returns to the previous screen.
(1)
(3)
(4)
(5)
(6)
(7)
(9)
(2)
(11) (10)
(8)