Grass Valley K2 Dyno v.1.6 - Manual (Page 170)

170 K2 Dyno Controller User Manual 15 April 2010
Chapter 10 Settings
Playback settings 3 (mark move, cut point, lever engage)
1. Touch < or > in the CONFIG screen, and then touch PLAY3 .
2. Set items.
3. Touch APPLY .
• When you touch APPLY , the settings are reflected.
• When you touch CANCEL , the settings are restored to the settings before
changes were made.
No. Name Function
(1) Move To Mark In "Preroll", set the pre-roll for a reverse playback to the In point of the
previous/next item when pressing the
Previous/Next button after the
Shift button. Touch the panel to enter a value.
In "Speed", set the speed for a reverse playback to the In point of the
previous/next item when pressing the
Previous/Next button after the
Shift button. Touch the panel to enter a value.
(2) Cut Point Preview Sets the pre-roll when IN PREV / OUT PREV is touched in the trim
mode. Touch the panel to enter a value. You must set a value of
00:00:10,00 or shorter.
(3) Lever Engage Mode Select Direct to reflect the T-Bar operation to the playback speed
immediately after you operate the T-Bar.
Select
Current Speed to reflect the T-Bar operation when it is set
faster than the current speed.
(1)
(2)
(3)