Grass Valley K2 Dyno v.1.6 - Manual (Page 107)

15 April 2010 K2 Dyno Controller User Manual 107
Trimming in a highlight
NOTE: For a highlight item stored from a playlist or event, the property edit screen
for playlists appear instead of the trim mode screen for highlights. For more
information, see
"Editing the property of a playlist" on page 134 .
3. Touch the panel you want to edit from the In, Out, or Dur panel, enter the timecode,
and then touch ENTER .
Either forward/rewind the item using the JOG knob or play the scene, and press the
In / Out button at the desired scene.
• Setting the In/Out point changes the duration automatically.
• Editing the duration automatically changes the timecode of the Out point. When
you want to change the duration with the Out point timecode fixed, you must
clear the In point timecode beforehand.
• Pressing the In / Out button sets the playback timecode, at the point when the
button is pressed, as the In/Out point.
• When you set the In/Out point (when you press the In / Out button), the respective
button lights up in green.
• If you press the Take button, the trim mode is finished to return to the previous
screen.
NOTE: For the button operation, you can also perform trimming using the
operation in step 3 without performing the step 2 operation after step 1 (without
displaying the trim mode screen). In this case, the result of your editing for
trimming will be reflected to all of the angles.
NOTE: If the timecodes of the In and Out points are already different in each angle,
you can turn off Separate Trim to perform trimming by the same variation values
for each angle.Touch the In/Out/Dur panel, touch "+" or "-", and then enter
values.
NOTE: When you trim an item, its protection range is also trimmed accordingly. If
the LoopRec setting is turned on and trimming that involves extension of the
duration is not possible due to the state of the record train or the available space on
the Summit, a warning mark is shown next to "In", "Out", or "Dur".
NOTE: Touch the In/Out/Dur panel in step 2 if you want to perform trimming
moving the playback pointer to the highlight item. Because no trimming to expand
the interval between In and Out points is allowed for this method, it is useful when
Button operation