Switching playlists – Grass Valley K2 Dyno v.1.6 User Manual
Page 135
15 April 2010
K2 Dyno Controller User Manual
135
Switching playlists
NOTE: If you cannot select the M/E pattern you want to set, check the setting in
"M/E" on the CONFIG screen. For more information, see
.
2. After editing the information by touching each panel, touch
BACK
.
Switching playlists
1. Touch the bin number/playlist name panel in the PLAYLIST screen.
(2)
In
Shows the In point timecode of the originally stored event in the
playlist side. Touch the panel to enter and change the timecode.
(3)
Dur
Shows the duration of the whole playlist.
(4)
TargetDur
If you touch the panel and enter the duration required for an on-air
broadcast, TargetSpeed is shown in the lower section. To cancel it,
touch
CLEAR
in the duration entry screen.
(5)
TargetSpeed
Shows the playback speed percentage for playing a playlist within the
target duration. The K2 Dyno Controller automatically sets this speed,
based on settings on the Play Options screen.
(6)
M/E pattern selection
Sets the effects to be used for switching stored events in a playlist at a
time.
(7)
Loop
Turn this on to perform a loop playback when playing a playlist. To
stop the loop playback, press the
Stop
button.
You cannot turn it on or off while playing a playlist. You must once
stop the playback, turn
Loop
on or off, and then play it again.
(8)
BACK
Returns to the PLAYLIST screen.
No.
Name
Function