Grass Valley K2 Dyno v.1.6 - Manual (Page 120)

120 K2 Dyno Controller User Manual 15 April 2010
Chapter 7 Editing a Playlist
Storing and deleting scenes in a playlist
You can edit important scenes to create a playlist. A scene, that is stored in a playlist,
is called an event.
The recording data of an event that is stored in a playlist will not be overwritten even
if the LoopRec setting is turned on. Only the angle when storing an item is saved. All
of the playlists are deleted when the session is deleted.
Storing events to a playlist
NOTE: You can store up to 200 events in a single playlist.
1. Select the item you want to store to the playlist.
• Items that are stored in a highlight/playlist as well as marks/scenes can be stored.
• Multiple items can be additionally selected while holding down the Fn button.
You can also press the Shift button, and then select a range of items while
holding down the Fn button.
NOTE: A mark and scene cannot be directly stored to a playlist while LoopRec is
ON. Store them in a highlight and then store the highlight in a playlist.
2. Touch the event panel in the PLAYLIST screen.
Press the Add PL button.
• The item is stored as the last one after the currently stored events.
• If you selected multiple items in step 1, the items are stored in the order in which
you selected them.
• When you store a marked item (with only an In point) as an event, the Out point
is set automatically using the default duration. For more information on how to
set the default duration, see
"Clip settings" on page 166 .
NOTE: If you want to insert a new event in a position of any stored item, select an
item to store, touch
COPY in the PLAYLIST screen, and then touch the event panel
where you want to insert the item.
Button operation