Grass Valley K2 Dyno v.1.6 - Manual (Page 30)

30 K2 Dyno Controller User Manual 15 April 2010
Chapter 2 Starting Up and Shutting Down
8. Assign the P1 or P2 button to the channel that you set as Player. If you want to
perform a LoopRec operation, set the allocation of the record train.
• For more information about the record train and LoopRec setting, see "About
the record train and LoopRec setting" on page 37 .
• To perform a LoopRec operation, touch LOOP REC to turn it on.
• If the LoopRec setting is turned on, you can change the train length allocation
by touching "Length". The maximum recording time for each train can be set by
entering the timecode. Set the length of the Loop Record to match the event's
duration. The Default Factory setting is 3:00:00:00.
• For the player to be used for an on-air live broadcast, turn on P1/PGM and assign
it to the P1 button.
NOTE: P1/PGM must be selected.
• For the player to be used for a preview, turn on P2/PVW and assign it to the P2
button.
• You can assign either one of the P1 or P2 button to the Player. In addition, you
cannot assign the same button to multiple channels.
• You can specify other various settings for the K2 Dyno Controller by touching
CONFIG . For more information about those settings, see "Settings" on page 163 .
NOTE: The Length setting only indicates the maximum recording time. The actual
available recording time depends on the remaining space in the Summit.
NOTE: A mark and scene cannot be directly stored to a playlist while LoopRec is
ON. Store them in a highlight and then store the highlight in a playlist.
9. Touch START .
• A session for the channel configuration you set is created.