Grass Valley K2 Dyno v.1.6 - Manual (Page 79)

15 April 2010 K2 Dyno Controller User Manual 79
Synchronizing playback status for multi-channel (Gang) mode channels
1. In the HOME screen, make sure that the controller is in the multi-channel mode.
• If the controller is in the multi-channel mode, the screen shows "MultiChannel".
• If the controller is in the on-air preview mode, the screen shows
"OnAirPreview". Switch to the multi-channel mode by pressing the PGM or
PVW button after pressing the Shift button.
2. Press the P1 button.
• The operation target channel is switched to the P1 channel.
3. Display the HIGHLIGHT screen, and cue up the item you want to use as the Key
video.
• For more information about the detailed operation procedures, see "Storing and
playing scenes in a highlight" on page 57 .
4. Adjust the playback start point of the Key video using the JOG knob.
5. Press the P2 button.
• The operation target channel is switched to the P2 channel.
6. Display the HIGHLIGHT screen, and cue up the item you want to use as the Fill
video.
7. Adjust the playback start point of the Fill video using the JOG knob.
• Adjust it according to the playback start point of the Key video you adjusted in
step 4.
8. Press the P1 and P2 buttons at the same time.
• The controller enters the Gang mode and the P1 and P2 buttons light up in red.
9. Press the Play button.
• The playback status of the Key and Fill video is synchronized.