Grass Valley K2 Dyno v.1.6 - Manual (Page 65)

15 April 2010 K2 Dyno Controller User Manual 65
Starting and stopping a recording
Controller
- Warning mark on the left: When the Summit is low on free space (10 mins x the
number of the recording channels)
- Caution mark on the left: When the Summit is low on free space (30 mins x the
number of the recording channels)
Starting and stopping a recording
Live playback
The data recorded in the Summit is played with the minimum time difference.
1. Check the camera angle.
2. Press the Live button.
• The recording begins, and "LIVE" is displayed in the HOME screen.
• The Live button will light up in red during a live playback.
NOTE: If you touch OA LOCK that is displayed at the bottom of the HOME screen,
operations to change the playback status, such as cueing up and replaying of the
item, operations with the T-Bar or JOG knob, and camera angle changes are
disabled, allowing for prevention of improper operations during a broadcast.
To turn off the on-air lock, either touch OA UNLOCK or press the Fn button and
then press the Stop button.
About the pseudo live mode
The system internally ends the live playback mode when the Play or In button is
pressed during a live playback, however, it continues to play the data being recorded
with the minimum time difference as with a live playback. This condition is referred
to as the "pseudo live mode". Since the system is not internally in the live playback
mode during the pseudo live mode, you must note that you cannot create a scene with
any JOG knob, T-Bar, or
Previous/Next button operation even if Auto Scene is
turned on in "CLIP" of the CONFIG screen.
In order to distinguish whether the current mode is the normal live playback mode or
the pseudo live mode, check the following indications:
• The word "LIVE" displayed in the HOME screen