Grass Valley K2 Dyno v.1.6 - Manual (Page 24)

24 K2 Dyno Controller User Manual 15 April 2010
Chapter 2 Starting Up and Shutting Down
Starting up
Starting up the K2 Dyno Controller
Before starting up the K2 Dyno Controller, turn on the K2 Summit Production Client
to use and start the application software in the Summit.
1. Turn on the K2 Summit Production Client.
2. Login K2 Summit Production Client with username (administrator) and password
(adminK2).
3. Start up AppCenter on the K2 Summit Production Client with user name
(administrator) and password (adminK2).
4. Turn on the K2 Dyno Controller.
• The power button is located on the rear side of the controller.
• The K2 Dyno Client software starts up automatically.
• When you start up the controller for the first time, you need to perform the initial
settings.
• See "Changing the channel configuration for standard channels" on page 25 about
the initial settings, and see "Using the existing sessions" on page 38 about using
the existing sessions.
Creating a new session
NOTE: When you start up the K2 Dyno Controller for the first time, you need to
perform the initial settings. For information about the initial settings, see
"Changing the channel configuration for standard channels" on page 25 .
1. Start up the K2 Dyno Controller.
• For information on how to start up the controller, see "Starting up the K2 Dyno
Controller" on page 24 .