Grass Valley K2 Dyno v.1.6 User Manual
Page 77
15 April 2010
K2 Dyno Controller User Manual
77
Switching the operation target channel in the multi-channel mode
6. Repeat steps 4 and 5.
• To turn off the preview control, either press the
P1
button or touch
PreviewCtrl
from the play options to turn it off.
Switching the operation target channel in the multi-channel mode
This section describes how to switch the operation target channel in the multi-channel
mode.
NOTE: You must assign two channels to be mainly used to the
P1
and
P2
buttons
beforehand. For more information, see
"Record train length allocation settings"
NOTE: You can switch among more than two channels if you operate the controller
using an expansion screen. For more information, see
.
1. In the HOME screen, make sure that the controller is in the multi-channel mode.
• If the controller is in the multi-channel mode, the screen shows "MultiChannel".
• If the controller is in the on-air preview mode, the screen shows
"OnAirPreview". Switch to the multi-channel mode by pressing the
PGM
or
PVW
button after pressing the
Shift
button.
2. Press the
P1
or
P2
button.
• The operation target channel is switched to the P1 or P2 channel.
• The button for the selected channel lights up in red.