H3C Technologies H3C SecPath F1000-E - Manual (Page 91)

25
To do… Use the command… Remarks
Enter test type view of a test group
type { dhcp | dlsw | dns | ftp
| http | icmp-echo | snmp |
tcp | udp-echo | udp-jitter |
voice }
—
Configure the descriptive string for
a test group
description text
Optional
By default, no descriptive string is
available for a test group.
Configure the interval between two
consecutive tests for a test group
frequency interval
Optional
By default, the interval between
two consecutive tests for a test
group is 0 milliseconds, that is,
only one test is performed.
If the last test is not completed
when the interval specified by the
frequency command is reached,
a new test is not started.
Configure the number of probes in
an NQA test
probe count times
Optional
By default, one probe is performed
in a test.
Only one probe can be made in
one voice test. Therefore, this
command is not available in a
voice test.
Configure the NQA probe timeout
time
probe timeout timeout
Optional
By default, the timeout time is 3000
milliseconds.
This parameter is not available for
a UDP jitter test.
Configure the maximum number of
hops a probe packet traverses in
the network
ttl value
Optional
20 by default.
This parameter is not available for
a DHCP test.
Configure the ToS field in an IP
packet header in an NQA probe
packet
tos value
Optional
0 by default.
This parameter is not available for
a DHCP test.
Enable the routing table bypass
function
route-option bypass-route
Optional
Disabled by default.
This parameter is not available for
a DHCP test.