H3C Technologies H3C SecPath F1000-E - Manual (Page 45)

44
[DeviceB] ipv6
[DeviceB] interface gigabitethernet 0/1
[DeviceB-GigabitEthernet0/1] ipv6 address fe80::2 link-local
[DeviceB-GigabitEthernet0/1] ipv6 address 1::2 64
# Create VRRP group 1 and set its virtual IPv6 addresses to FE80::10 and 1::10.
[DeviceB-GigabitEthernet0/1] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
[DeviceB-GigabitEthernet0/1] vrrp ipv6 vrid 1 virtual-ip 1::10
# Create VRRP group 2 set its virtual IPv6 addresses to FE80::20 and 1::20.
[DeviceB-GigabitEthernet0/1] vrrp ipv6 vrid 2 virtual-ip fe80::20 link-local
[DeviceB-GigabitEthernet0/1] vrrp ipv6 vrid 2 virtual-ip 1::20
# Set the priority of Device B in VRRP group 2 to 110.
[DeviceB-GigabitEthernet0/1] vrrp ipv6 vrid 2 priority 110
# Enable Device B to send RA messages.
[DeviceB-GigabitEthernet0/1] undo ipv6 nd ra halt
Step3 Verify the configuration
To verify your configuration, use the display vrrp ipv6 verbose command.
# Display detailed information of the VRRP group on Device A.
[DeviceA-GigabitEthernet0/1] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 2
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 100
Admin Status : Up State : Master
Config Pri : 110 Running Pri : 110
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : FE80::10
1::10
Virtual MAC : 0000-5e00-0201
Master IP : FE80::1
Interface GigabitEthernet0/1
VRID : 2 Adver Timer : 100
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : FE80::20
1::20
Master IP : FE80::2
# Display detailed information of the VRRP group on Device B.
[DeviceB-GigabitEthernet0/1] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode : Standard