H3C Technologies H3C SecPath F1000-E User Manual

Page 42

[DeviceB-GigabitEthernet0/2] ipv6 address 1::2 64

# Create a VRRP group 1 and set its virtual IPv6 addresses to FE80::10 and 1::10.

[DeviceB-GigabitEthernet0/2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local

[DeviceB-GigabitEthernet0/2] vrrp ipv6 vrid 1 virtual-ip 1::10

# Set the authentication mode of VRRP group 1 as simple and authentication key as hello.

[DeviceB-GigabitEthernet0/2] vrrp ipv6 vrid 1 authentication-mode simple hello

# Set the interval between sending VRRP advertisements to 500 centiseconds.

[DeviceB-GigabitEthernet0/2] vrrp ipv6 vrid 1 timer advertise 500

# Set Device B to work in preemptive mode. The preemption delay is five seconds.

[DeviceB-GigabitEthernet0/2] vrrp ipv6 vrid 1 preempt-mode timer delay 5

# Enable Device B to send RA messages.

[DeviceB-GigabitEthernet0/2] undo ipv6 nd ra halt

Step3

Verify the configuration

After the configuration, Host B can be pinged successfully on Host A. To verify your configuration, use the
display vrrp ipv6 verbose command.
# Display detailed information of VRRP group 1 on Device A.

[DeviceA-GigabitEthernet0/2] display vrrp ipv6 verbose

IPv6 Standby Information:

Run Mode : Standard

Run Method : Virtual MAC

Total number of virtual routers : 1

Interface GigabitEthernet0/2

VRID : 1 Adver Timer : 500

Admin Status : Up State : Master

Config Pri : 110 Running Pri : 110

Preempt Mode : Yes Delay Time : 5

Auth Type : Simple Key : hello

Virtual IP : FE80::10

1::10

Virtual MAC : 0000-5e00-0201

Master IP : FE80::1

VRRP Track Information:

Track Interface: GE0/1 State : Up Pri Reduced : 30

# Display detailed information of VRRP group 1 on Device B.

[DeviceB-GigabitEthernet0/2] display vrrp ipv6 verbose