H3C Technologies H3C SecPath F1000-E - Manual (Page 295)

12
[DeviceA-nqa-admin-test-icmp-echo] frequency 100
# Configure reaction entry 1, specifying that five consecutive probe failures trigger the track-NQA
collaboration.
[DeviceA-nqa-admin-test-icmp-echo] reaction 1 checked-element probe-fail threshold-type
consecutive 5 action-type trigger-only
[DeviceA-nqa-admin-test-icmp-echo] quit
# Start NQA probes.
[DeviceA] nqa schedule admin test start-time now lifetime forever
Step3 Configure a track entry on Device A.
# Configure track entry 1, and associate it with reaction entry 1 of the NQA test group (with the
administrator admin, and the operation tag test).
[DeviceA] track 1 nqa entry admin test reaction 1
Step4 Configure VRRP on Device A.
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[DeviceA] interface gigabitEthernet0/1
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the priority of Device A in VRRP group 1 to 110.
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 priority 110
# Set the authentication mode of VRRP group 1 to simple, and the authentication key to hello.
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 authentication-mode simple hello
# Configure the master to send VRRP packets at an interval of five seconds.
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 timer advertise 5
# Configure Device A to work in preemptive mode, and set the preemption delay to five seconds.
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 preempt-mode timer delay 5
# Configure to monitor track entry 1 and specify the priority decrement to 30.
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 track 1 reduced 30
Step5 Configure VRRP on Device B.
< DeviceB> system-view
[DeviceB] interface gigabitEthernet0/1
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[DeviceB-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the authentication mode of VRRP group 1 to simple, and the authentication key to hello.
[DeviceB-GigabitEthernet0/1] vrrp vrid 1 authentication-mode simple hello
# Configure the master to send VRRP packets at an interval of five seconds.
[DeviceB-GigabitEthernet0/1] vrrp vrid 1 timer advertise 5
# Configure Device B to work in preemptive mode, and set the preemption delay to five seconds.
[DeviceB-GigabitEthernet0/1] vrrp vrid 1 preempt-mode timer delay 5
Step6 Verify the configuration