H3C Technologies H3C SecPath F1000-E - Manual (Page 315)

32
Total number of virtual routers : 1
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : 10.1.1.10
Master IP : 10.1.1.1
The output information shows that in VRRP group 1, Device A is the master and Device B is a backup.
Packets from Host A to Host B are forwarded through Device A.
# Shut down the uplink interface GigabitEthernet 0/2 on Device A.
[DeviceA-GigabitEthernet0/1] interface gigabitethernet0/2
[DeviceA-GigabitEthernet0/2] shutdown
After shutting down the uplink interface on Device A, you can still successfully ping Host B on Host A.
Use the display vrrp command to view information about VRRP group 1.
# After shutting down the uplink interface on Device A, display detailed information about VRRP group
1 on Device A.
[DeviceA-GigabitEthernet0/2] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers f: 1
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Backup
Config Pri : 110 Running Pri : 80
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : 10.1.1.10
Master IP : 10.1.1.2
VRRP Track Information:
Track Object : 1 State : Negative Pri Reduced : 30
# After shutting down the uplink interface on Device A, display detailed information about VRRP group
1 on Device B.
[DeviceB- GigabitEthernet0/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Master
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 0