H3C Technologies H3C SecPath F1000-E - Manual (Page 214)

20
Displaying and Maintaining Basic System
Configurations
To do… Use the command… Remarks
Display information on system
version
display version
Display information on the system
clock
display clock
Display defined command aliases
and the corresponding commands display command-alias
Display information on terminal
users
display users [ all ]
Display the users that have logged
in to the device and that are not in
user view
display configure-user
Display the valid configuration
under current view
display this [ by-linenum ]
Display clipboard information display clipboard
Display and save statistics of the
running status of multiple modules display
diagnostic-information
Available in any view
During daily maintenance or when the system is operating abnormally, you need to display the running
status of each functional module to locate the problem. Generally, you need to execute the
corresponding display commands for each module, because each module has independent running
information. To collect more information at one time, you can execute the display
diagnostic-information command to display or save the statistics of the running status of multiple
modules in the system. Execution of the display diagnostic-information command equals
execution of the commands display clock, display version, display device, and display
current-configuration one by one.
NOTE:
•
For more information about the display users command, see User Interface Commands in the System
Volume.
• The display commands discussed above are for the global configuration. See the corresponding section
for the display command for specific protocol and interface.