H3C Technologies H3C SecPath F1000-E - Manual (Page 314)

31
Step2 Configure a track entry on Device A.
# Configure track entry 1, and associate it with the physical status of the uplink interface GigabitEthernet
0/2.
[DeviceA] track 1 interface gigabitethernet0/2
Step3 Configure VRRP on Device A.
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[DeviceA] interface gigabitethernet0/1
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the priority of Device A in VRRP group 1 to 110.
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 priority 110
# Configure to monitor track entry 1 and specify the priority decrement as 30.
[DeviceA-Ethernet1/1] vrrp vrid 1 track 1 reduced 30
Step4 Configure VRRP on Device B.
system-view
[DeviceA-GigabitEthernet0/1] vrrp vrid 1 track 1 reduced 30
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[DeviceB-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.1.1.10
Step5 Verify the configuration
After configuration, ping Host B on Host A, and you can see that Host B is reachable. Use the display
vrrp command to view the configuration result.
# Display detailed information about VRRP group 1 on Device A.
[DeviceA-Ethernet1/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
[DeviceA-GigabitEthernet0/1] display vrrp verbose
VRID : 1 Adver Timer : 1
Admin Status : Up State : Master
Config Pri : 110 Running Pri : 110
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : 10.1.1.10
Virtual MAC : 0000-5e00-0101
Master IP : 10.1.1.1
VRRP Track Information:
Track Object : 1 State : Positive Pri Reduced : 30
# Display detailed information about VRRP group 1 on Device B.
[DeviceB-GigabitEthernet0/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC