H3C Technologies H3C SecPath F1000-E - Manual (Page 72)

6
Task Remarks
Configuring an FTP Test
Configuring a DNS Test
Configuring an HTTP Test
Configuring a UDP Jitter Test
Configuring an SNMP Test
Configuring a TCP Test
Configuring a UDP Echo Test
Configuring a Voice Test
Configuring a DLSw Test
Configuring the Collaboration Function Optional
Configuring Threshold Monitoring Optional
Configuring the NQA Statistics Function Optional
Configuring the History Records Saving Function Optional
Configuring Optional Parameters Common to an NQA Test Group Optional
Scheduling an NQA Test Group Required
Configuring the NQA Server
Before performing TCP, UDP echo, UDP jitter, or voice tests, configure the NQA server on the peer device.
The NQA server makes a response to the request sent by the NQA client by listening to the specified
destination address and port number.
Follow these steps to configure the NQA server:
To do… Use the command… Remarks
Enter system view system-view —
Enable the NQA server nqa server enable
Required
Disabled by default.
Configure the listening service on
the NQA server
nqa server { tcp-connect |
udp-echo } ip-address
port-number
Required
The IP address and port number
must be consistent with those
configured on the NQA client and
must be different from those of an
existing listening service.