H3C Technologies H3C SecPath F1000-E - Manual (Page 105)

39
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of UDP echo tests.
[DeviceA] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
1 25 Succeeded 2007-11-22 10:36:17.9
Voice Test Configuration Example
Network requirements
As shown in Figure 12 , use the NQA voice function to test the delay jitter of voice packet transmission
and voice quality between Device A and Device B.
Figure 12 Network diagram for voice tests
Configuration procedure
Step1 Configure Device B
# Enable the NQA server and configure the listening IP address as 10.2.2.2 and port number as 9000.
system-view
[DeviceB] nqa server enable
[DeviceB] nqa server udp-echo 10.2.2.2 9000
Step2 Configure Device A
# Create a voice test group and configure related test parameters.
system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type voice
[DeviceA-nqa-admin-test-voice] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-voice] destination port 9000
[DeviceA-nqa-admin-test-voice] quit
# Enable voice test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Disable the voice test after the test begins for a period of time.
[DeviceA] undo nqa schedule admin test
# Display the result of the last voice test.
[DeviceA] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Destination IP address: 10.2.2.2