H3C Technologies H3C SecPath F1000-E - Manual (Page 153)

3
Figure 2 MIB tree
A
2
6
1
5
2 1
1
2
1
B
SNMP Configuration
Because SNMPv3 configurations differ from SNMPv1 and SNMPv2c configurations, their SNMP
functionalities are introduced separately as follows.
Follow these steps to configure SNMPv3:
To do… Use the command… Remarks
Enter system view system-view —
Enable the SNMP agent snmp-agent
Optional
Disabled by default
You can enable the SNMP agent
through this command or any
command that begins with
snmp-agent.
Configure SNMP agent system
information
snmp-agent sys-info
{ contact sys-contact | location
sys-location | version { all | { v1
| v2c | v3 }* } }
Optional
The defaults are as follows:
Hangzhou H3C Technologies Co.,
Ltd. for contact; Hangzhou China
for location, and SNMP v3 for the
version.
Configure a local engine ID for an
SNMP entity snmp-agent local-engineid
engineid
Optional
Company ID and device ID by
default.
Create or update the MIB view
content for an SNMP agent
snmp-agent mib-view
{ excluded | included }
view-name oid-tree [ mask
mask-value ]
Optional
By default, the MIB view name is
ViewDefault and OID is 1.
Configure an SNMP agent group
snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
Required