H3C Technologies H3C SecPath F1000-E - Manual (Page 90)

24
Configuring the History Records Saving Function
With the history records saving function enabled, the system saves the history records of the NQA test.
To view the history records of a test group, use the display nqa history command.
The configuration task also allows you to configure:
• Lifetime of the history records: The records are removed when the lifetime is reached.
• The maximum number of history records that can be saved in a test group: If the number of history
records in a test group exceeds the maximum number, the earliest history records are removed.
Follow these steps to configure the history records saving function of an NQA test group:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view nqa entry admin-name operation-tag —
Enter NQA test type view
type { dhcp | dlsw | dns | ftp | http |
icmp-echo | snmp | tcp | udp-echo |
udp-jitter | voice }
—
Enable the saving of the
history records of the NQA
test group
history-record enable
Required
By default, history records of
the NQA test group are not
saved.
Set the lifetime of the history
records in an NQA test
group
history-record keep-time keep-time
Optional
By default, the history records in
the NQA test group are kept for
120 minutes.
Configure the maximum
number of history records
that can be saved in a test
group
history-record number number
Optional
By default, the maximum
number of records that can be
saved in a test group is 50
Configuring Optional Parameters Common to an
NQA Test Group
Optional parameters common to an NQA test group are valid only for tests in this test group.
Unless otherwise specified, the following parameters are applicable to all test types and they can be
configured according to the actual conditions.
Follow these steps to configure optional parameters common to an NQA test group:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—