H3C Technologies H3C SecPath F1000-E - Manual (Page 80)

14
To do… Use the command… Remarks
Configure the destination port for a
test operation
destination port port-number
Required
By default, no destination port
number is configured for a test
operation.
The destination port must be
consistent with that of the existing
listening service on the NQA
server.
Specify the source port number for
a request
source port port-number
Optional
By default, no source port number
is specified.
Configure the size of a probe
packet sent
data-size size
Optional
100 bytes by default.
Configure the filler string of a
probe packet sent
data-fill string
Optional
By default, the filler string of a
probe packet is the hexadecimal
number
00010203040506070809.
Configure the number of packets
sent in a UDP jitter probe probe packet-number
packet-number Optional
10 by default.
Configure the interval for sending
packets in a UDP jitter probe
probe packet-interval
packet-interval
Optional
20 milliseconds by default.
Configure the time for waiting for a
response in a UDP jitter test probe packet-timeout
packet-timeout
Optional
3000 milliseconds by default.
Configure the source IP address of
a probe request in a test operation source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be that
of an interface on the device and
the interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
See Configuring Optional
Parameters Common to an NQA
Test Group
Optional
NOTE:
The number of probes made in a UDP jitter test depends on the probe count command. The number of
probe packets sent in each probe depends on the configuration of the probe packet-number command.
Configuring an SNMP Test
An SNMP query test is used to test the time the NQA client takes to send an SNMP query packet to the
SNMP agent and then receive a response packet.