H3C Technologies H3C SecPath F1000-E - Manual (Page 165)

1
MIB Style Configuration
This chapter includes these sections:
• Setting the MIB Style
• Displaying and Maintaining MIB
H3C private MIB involves two styles, H3C compatible MIB and H3C new MIB. In the H3C compatible
MIB style, the device sysOID is under the H3C’s enterprise ID 25506, and the private MIB is under the
enterprise ID 2011. In the H3C new MIB style, both the device sysOID and the private MIB are under the
H3C’s enterprise ID 25506. These two styles of MIBs implement the same management function except
for their root nodes. A device is shipped with MIB loaded and the MIB style may vary depending on the
device model. To implement NMS’s flexible management of the device, the device allows you to
configure the MIB style, that is, you can switch between the two styles of MIBs. However, you need to
ensure that the MIB style of the device is the same as that of the NMS.
Setting the MIB Style
Follow these steps to set the MIB style:
To do… Use the command… Remarks
Enter system view system-view —
Set the MIB style of the device
mib-style [ new |
compatible ] Optional
new by default
NOTE:
The modified MIB style takes effect only after you reboot the device. Therefore, you are recommended to
reboot the device after setting the MIB style to ensure that modification of the MIB style takes effect.
Displaying and Maintaining MIB
To do… Use the command… Remarks
Display the MIB style display mib-style Available in any view