H3C Technologies H3C SecPath F1000-E - Manual (Page 299)

16
# Create VRRP group 1, and configure the virtual IP address 192.168.0.10 for the group. VRRP group 1
monitors the status of track entry 1. When the status of the track entry becomes Negative, Device B
becomes the master quickly.
[DeviceB] interface gigabitethernet 1/1
[DeviceB-GigabitEthernet1/1] vrrp vrid 1 virtual-ip 192.168.0.10
[DeviceB-GigabitEthernet1/1] vrrp vrid 1 track 1 switchover
[DeviceB-GigabitEthernet1/1] return
Step5 Verify the configuration
# Display the detailed information of VRRP group 1 on Device A.
display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface GigabitEthernet1/1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Master
Config Pri : 110 Running Pri : 110
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : 192.168.0.10
Virtual MAC : 0000-5e00-0101
Master IP : 192.168.0.101
# Display the detailed information of VRRP group 1 on Device B.
display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface GigabitEthernet1/1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : 192.168.0.10
Master IP : 192.168.0.101
VRRP Track Information:
Track Object : 1 State : Positive Switchover
# Display information about track entry 1 on Device B.
display track 1
Track ID: 1
Status: Positive
Notification delay: Positive 0, Negative 0 (in seconds)
Reference object:
BFD session: